cleaned up the repository and renamed stuff

Blink2015/Blink2015.ino

@@ -1,29 +1,10 @@
-/*
-  Blink
-  Turns on an LED on for one second, then off for one second, repeatedly.
-
-  Most Arduinos have an on-board LED you can control. On the Uno and
-  Leonardo, it is attached to digital pin 13. If you're unsure what
-  pin the on-board LED is connected to on your Arduino model, check
-  the documentation at http://www.arduino.cc
-
-  This example code is in the public domain.
-
-  modified 8 May 2014
-  by Scott Fitzgerald
- */
-
-
-// the setup function runs once when you press reset or power the board
 void setup() {
-  // initialize digital pin 13 as an output.
   pinMode(13, OUTPUT);
 }
 
-// the loop function runs over and over again forever
 void loop() {
-  digitalWrite(13, HIGH);   // turn the LED on (HIGH is the voltage level)
-  delay(1000);              // wait for a second
-  digitalWrite(13, LOW);    // turn the LED off by making the voltage LOW
-  delay(1000);              // wait for a second
+  digitalWrite(13, HIGH);
+  delay(1000);
+  digitalWrite(13, LOW);
+  delay(1000);
 }